Operate lock using the driver side door lock and unlock switch. YES-2 > When ending registration: GO TO STEP 8. , Lightweight concrete development program, Phase i. YES-1 > When adding a keyfob: GO TO STEP 6. , Thermal efficiency of flat plate solar collectors, 79 : 2218 See. Within 3 seconds after the hazard lamp blinks and all door unlocks, turn ignition switch to the ACC position and operate lock using the driver side door lock and unlock switch.ġ.Press the lock or unlock button of the keyfobto be added.ģ.Hazard warning lamp blinks and all door unlocks. Nissan J2534-1 software does not support key programming. Access the CONSULT Updates menu item to obtain these updates. Future software updates may be purchased from Nissan’s Service Information Website,. NOTE:On the sixth key insertion, keep the key in the cylinder with the key barrel switch ON.Does the hazard lamp blink and all doors unlock?YES > GO TO STEP 4.NO > GO TO STEP 1. Refer to BCM Replacement procedure in the appropriate service manual, when a registered key is not available. Operate lock using the driver side door lock and unlock switch (on P/Window swassy.)ġ.Remove and insert the key into the ignition key 6 times within 10 seconds (turning the key barrel switch from OFF to ON counts as 1 time).Ģ.Hazard warning lamp blinks and all door unlocks. XTOOL X100 PAD3 with KS-1 Auto Key Programmer Immobilizer Actuation Test Full System OBDII Diagnostic Tool Code Readers Scan Tools BCM/SRS/ABS Bleeding All Key. Thank you for any useful information you can provide.4.When the next screen appears, (section shown below) select “REMO CONT ID REGIST” function to program the remotes.Ĭlose all doors (Observe the operation of the interior light with each door to ensure the door switches are OK). Can it be done? And equally important, can it be done by anyone (such as me) other than a dealer service department? Now I have the opposite situation - I need to reprogram the car to a new fob. thumbnail 1 - Nissan Micra K12 - Note BCM Body Control Module Programming. When I got a new key fob, I was able to program it to the car without any trouble. This service is for all Nissan part number BCM -L2 / N / AC /NAC etc similar. My question is whether or not the BCM can be reprogrammed with a new key code (probably not the correct terminology) so that the old key no longer has the ability to start the car. I know, he is an idiot for keeping the broken key in the car, so no comments necessary in that regard. The defective key was in the car when it was stolen, and it had the ability to start the car when inserted manually. The bad news is that his Intelligent Key failed recently, so we got a replacement. The car was recovered with minimal damage, so that's good news. Hello Nissan Redditors! My son has a 2009 Altima 2.5S that was stolen earlier this week.

Programming nissan bcm